Cisco D9800 User Manual

DescriptionCommand Detail
One of the following:
GET "https://192.168.0.1/ws/v2/service_cfg/input/moip", or
GET "https://192.168.0.1/ws/v2/service_cfg/input/moip?
stream=[stream#]&act"
GET Syntax
POST "https://192.168.0.1/ws/v2/service_cfg/input/moip?
stream=[stream#]&act=Yes..."
POST Syntax
URI Parameters (extension to the Command URL separated by /): N/A
Setting Parameters using command line arguments are limited to maximum of 26 arguments after
the ?.
Note
All of the URI Arguments below apply to both GET and POST. For GET, the URI arguments do not
need any values, except the stream which must be specified. For POST the stream must be specified
followed by any of the below URI arguments and the associated value the user would like to set.
In-depth CURL examples can be seen below following the table.
Note
Table 139: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
DescriptionURI Argument
Multi Input Path Stream ID.
Type: Integer
Values: 1..32
stream (Key)
(Mandatory)
Activate Input
Type: String
Values: "Yes" or "No"
act
IP address selection method.
Type: String
Values: "SW Map" or "UserCfg"
ipmode
FEC mechanism.
Type: String
Values: "None", "1D", or "2D"
fecmode
Use multicast address.
Type: String
Values: "Yes" or "No"
usemcast
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
150
API Definitions
Input Configuration Command

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English