Video Decode Configuration Command
Table 169: Command Details
DescriptionCommand Detail
https://192.168.0.1/ws/v2/service_cfg/decode/videoCommand URL
Allows set or get of video decode settings parameters.Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
One of the following:
GET "https://192.168.0.1/ws/v2/service_cfg/decode/video", or
GET "https://192.168.0.1/ws/v2/service_cfg/decode/video? pvformat"
GET Syntax
POST
"https://192.168.0.1/ws/v2/service_cfg/decode/video?pvformat=[value]&sdformat=[value]"
POST Syntax
Setting Parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
URI Query/Set Arguments (possible fields and values preceded by ? and separated by &):
For GET, the URI arguments below will not contain values. For POST, the arguments below will need to
be specified with a value. In-depth CURL examples can be seen below
Note
Trisync is not supported in the current release. It may still be accepted as an input Query/Set Argument
and shown in the output return body data in software Version 2.27 or below. The client software should
ignore and not use or display this field.
Note
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
204
API Definitions
Decode Configuration Commands
To Next Page
Loading...
