The full CC settings table is the same as just retrieving it with the prefccmode argument as the prefccmode
argument is the only argument of CC.
Note
Audio Decode Configuration Command
The audio decode configuration command is only supported in Version 1.x to 2.05.Note
Table 177: Command Details
DescriptionCommand Detail
https://192.168.0.1/ws/v2/service_cfg/decode/audioCommand URL
Allows set or get of audio decode settings parameters.Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
One of the following:
GET "https://192.168.0.1/ws/v2/service_cfg/decode/audio",
GET
"https://192.168.0.1/ws/v2/service_cfg/decode/audio?device=[device#]
&mode&ac3comp&left&right&
pmtsrc&ddpmode&langmenu&lang", or
GET "https://192.168.0.1/ws/v2/service_cfg/decode/audio?
device=all"
This option is available in Version 2.75 or
later.
Note
This command format is currently equivalent to specifying the GET
operation for service_cfg/device/audio without any Query arguments. It
will return the complete data for all Audio device instances. Other filter
parameters will currently be ignored when specified along with the GET
device=all key for this command.
GET Syntax
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
212
API Definitions
Decode Configuration Commands
To Next Page
Loading...
Need help?
General
