Cisco D9800 User Manual

Decode Configuration Commands
This section lists the decode configuration commands.
Control Decode Configuration Command
Table 167: Command Details
DescriptionCommand Detail
https://192.168.0.1/ws/v2/service_cfg/decode/ctrlCommand URL
Allows set or get of decoder enable/disable control parameters.Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
GET "https://192.168.0.1/ws/v2/service_cfg/decode/ctrl", or
GET "https://192.168.0.1/ws/v2/service_cfg/decode/ctrl?decoder=[value]"
GET Syntax
POST
"https://192.168.0.1/ws/v2/service_cfg/decode/ctrl?decoder=video&enable=Yes"
POST Syntax
Setting Parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
For GET, the URI arguments below will not contain values, except for the decoder argument which
if used must contain the value for the specific decoder users would like to retrieve information about.
For POST, the arguments below will need to be specified with a value. In-depth CURL examples
can be seen below.
Note
Table 168: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
DescriptionURI Argument
Decoder Identifier
Type: String
Values: "Video", "Audio1", "Audio2", "Audio3", "Audio4", "VBI",
"Data","MPE1", "MPE2", "MPE3", "MPE4", "MPE5", "STT", "DPI"
decoder
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
202
API Definitions
Decode Configuration Commands

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English