Cisco D9800 User Manual

If successful, the following example is the return body:
"transcode": {
"hd": {
"index": "5",
"bitrate": "16.0"
}
}
Example 5: GET multiple HD transcoder values for a specific transcoder
The following example assumes that the user has successfully logged onto the unit, received the session id
and set it to the variable token. In addition, it is assumed that the IP of the unit is 192.168.0.1. You must
change the IP to the specific unit IP in use. The following example retrieves multiple parameter values from
the HD transcoder settings for transcoder 5.
The user must specify the port number in the URI followed by the URI arguments the user wishes to
retrieve. This example retrieves the bitratemode, bitrate and pulldown32 values from transcoder 5.
Note
In GET URIs, only the index argument must contain a value for the transcoder, all other arguments do
not contain values.
Note
curl -X GET -i -H "Accept: application/json" -H "X-SESSION-ID: $token" -k
"https://192.168.0.1/ws/v2/service_cfg/transcode/hd?index=5&bitratemode&bitrate&pulldown32"
If successful, the following is an example of the return body:
"transcode": {
"hd": {
"index": "5",
"bitrate": "16.0",
"bitratemode": "CBR",
"pulldown32": "Disabled"
}
}
SD Transcode Configuration Command
Table 209: Command Details
DescriptionCommand Detail
https://192.168.0.1/ws/v2/service_cfg/transcode/sdCommand URL
Allows set or get of SD transcode configuration.Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
248
API Definitions
Transcoding Configuration Commands

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English