DPM ASI/MOIP PE Output Configuration Command
Table 163: Command Details
DescriptionCommand Detail
Single-stream (NTC Basic, NTC MOIP), asi output port (only one output
exists):
https://192.168.0.1/ws/v2/service_cfg/output/asi/pe
Or alternatively,
Single-stream (NTC Basic, NTC MOIP), asi output port (only one output
exists):
https://192.168.0.1/ws/v2/service_cfg/output/asi2/pe
Single-stream (NTC Basic): MOIP is not supported.
Single-stream (NTC MOIP), only one unique moip output available:
https://192.168.0.1/ws/v2/service_cfg/output/moip/pe, or
https://192.168.0.1/ws/v2/service_cfg/output/moip1/pe
Multi-stream, asi or moip output port 1:
https://192.168.0.1/ws/v2/service_cfg/output/asi1/pe
https://192.168.0.1/ws/v2/service_cfg/output/moip1/pe
Multi-stream unit, asi or moip output port 2:
https://192.168.0.1/ws/v2/service_cfg/output/asi2/pe
https://192.168.0.1/ws/v2/service_cfg/output/moip2/pe
Command URL
Allows set or get of ASI or MOIP DPM PE output parameters.Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
193
API Definitions
Output Configuration Command
To Next Page
Loading...
