Cisco D9800 User Manual

Audio Device SDI1 or SDI2 Output Settings Command
Table 181: Command Details
DescriptionCommand Detail
https://192.168.0.1/ws/v2/service_cfg/decode/audio (for SDI1 or SDI2
Output Settings)
Command URL
Allows set or get of audio decode SDI1 or SDI2 output settings
parameter.
Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
GET "https://192.168.0.1/ws/v2/service_cfg/decode/audio? sdi1output"GET Syntax
POST "https://192.168.0.1/ws/v2/service_cfg/decode/audio?
sdi1output=[sdi1_stringvalue]…"
POST Syntax
Setting parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
All of the URI Arguments below apply to both GET and POST. For GET, the URI arguments do not
need any values. For POST at least one of the arguments must be specified along with the associated
value the user would like to set. In-depth CURL examples can be seen below following the table.
Note
Table 182: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
DescriptionURI Argument
SDI1 Output Mode
Type: String
Value: "PVO", "SD"
Sdi1output
SDI2 Output Mode
Type: String
Value: "PVO", "SD"
Sdi2output
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
220
API Definitions
Decode Configuration Commands

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English