Cisco D9800 User Manual

The following example assumes that the user has successfully logged onto the unit, received the session ID,
and set it to the variable token. In addition, it is assumed that the IP of the unit is 192.168.0.1. You must
change the IP to the specific unit IP in use. The following example sets Program Entry ID 1 to ON.
curl -X POST -i -H "Accept: application/json" -H "X-SESSION-ID:$token" -k
"https://192.168.0.1/ws/v2/service_cfg/ca/pe?peid=1&cidecrypt=ON"
GET Examples:
Example 2: Retrieve the PE Settings
The following example assumes that the user has successfully logged onto the unit, received the session ID,
and set it to the variable token. In addition, it is assumed that the IP of the unit is 192.168.0.1. You must
change the IP to the specific unit IP in use.
curl -X GET -i -H "Accept: application/json" -H "X-SESSION-ID: $token" -k
"https://192.168.0.1/ws/v2/service_cfg/ca/pe"
If successful, the following is an example of the return body:
{
"ca": {
"pe": [
{
"peid": "1",
"cidecrypt": "ON",
"cislot": "TOP",
"cipe1slot": "TOP"
},
…
{
"peid": "16",
"cidecrypt": "ON",
"cislot": "TOP",
"cipe1slot": "AUTO"
}
]
}
}
CICOMP CA Configuration Command
Table 205: Command Details
DescriptionCommand Detail
https://192.168.0.1/ws/v2/service_cfg/ca/cicompCommand URL
Allows set or get of Conditional Access CI Component level
configuration.
Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
241
API Definitions
CA (Conditonal Access) Configuration Commands

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English