Cisco D9800 User Manual

DescriptionSDI VII Argument
Specify for POST operation only
Enable or Disable VII Service
Type: String
Value: "Enabled", "Disabled"
enable
The possible URI for both POST and GET for sdivanc, sdiaudio, and sdivii are seen above. Please place
these URIs into the CURL command with a valid token and users will be able to POST and GET. Refer
to the POST and GET syntax examples in the Command Details section above for examples on how to
do GET and POST with CURL commands.
Note
HDMI Decode Configuration Command
Table 189: Command Details
DescriptionCommand Detail
https://192.168.0.1/ws/v2/service_cfg/decode/hdmiCommand URL
Allows set or get of decode settings for HDMI parameters.Command Information
GET, POSTHTTP Methods
Read, WriteAccess Type
User, AdminAccess Level
All HDMI Video Settings for specified HDMI instance:
GET "https://192.168.0.1/ws/v2/service_cfg/decode/hdmi? hdmiindex=1"
Single HDMI Video Setting for specified HDMI instance:
GET "https://192.168.0.1/ws/v2/service_cfg/decode/hdmi?
hdmiindex=1&colorspace"
GET Syntax
Single HDMI Video setting:
POST "https://192.168.0.1/ws/v2/service_cfg/decode/hdmi?
hdmiindex=1&colorspace=YCbCr420"
Multiple HDMI Video settings:
POST "https://192.168.0.1/ws/v2/service_cfg/decode/hdmi?
hdmiindex=1&colorspace=YCbCr422&colorrange=Full&eotf=HDR"
POST Syntax
Setting parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
226
API Definitions
Decode Configuration Commands

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English