Cisco D9800 - Page 226

DescriptionURI Argument
right volume
Type : Float
Value: -6.0 .. 6.0
Right
PMT Audio Source
Type: String
Value: "AUD1", "AUD2", ……. "AUD64"
pmtsrc
Dolby Digital Mode
Type: String
Value: "Trans", "Pass"
ddpmode
Language Selection Menu option
Type: String
Value: "Language List", "Language Entry", "PMT Order"
langmenu
Language Value.
Type: String
Value: Any valid 3 character language code, for example, "eng"
lang
POST Examples:
Example 1: Set various Audio Setting Arguments
The following example assumes that the user has successfully logged onto the unit, received the session ID,
and set it to the variable token. In addition, it is assumed that the IP of the unit is 192.168.0.1. You must
change the IP to the specific unit IP in use. This example sets the ddpmode to Pass.
The device index must be specified in the URI. For this example the ddpmode will be set for audio device
1.
Note
curl -X POST -i -H "Accept: application/json" -H "X-SESSION-ID: $token" -k
"https://192.168.0.1/ws/v2/service_cfg/decode/audio?ddpmode=Pass&device=1"
If successful, the return body will look like:
"response": {
"code": "10",
"result": "success",
"message": ""
}
GET Examples:
Example 2: Retrieve the full Audio Settings for a specific device
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
214
API Definitions
Decode Configuration Commands