Cisco D9800 User Manual

DescriptionCommand Detail
POST “https://192.168.0.1/ws/v2/service_cfg/ca/biss?
bissmode=Mode%201"
POST Syntax
Setting parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
For POST, the value for the argument seen below must be specified, but for GET there are no values
for arguments. Also, the write only commands that can be used for POST are noted below.
Note
Table 200: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
DescriptionURI Argument
Input port to be configured.
Type: Integer
Values: 1 .. 16 (NFE), 1 .. 2 (ASI), 2 (MOIP)
port (Key)
Applies to multi-stream units only.
Multi Input Stream ID. If not specified, default value of 1 is used.
Type: Integer
Values: 1..6 (RF), 2 (ASI), 1..32 (MOIP)
stream (Key)
(optional)
Applies to multi-stream units only.
BISS Mode of operation
Type: String
Value: "Mode 1", "Mode E"
bissmode
Mode-1 Session Word
Type: String
Value: String with 12 characters
mod1seswrd
(Write Only)
Mode-E Encrypted Session Word
Type: String
Value: String with 16 characters
modeseswrd
(Write Only)
Mode-e Injected ID
Type: String
Value: String with 14 characters
modeinjid
(Write Only)
POST Examples:
Example 1: Set various BISS Setting Arguments
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
236
API Definitions
CA (Conditonal Access) Configuration Commands

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English