Cisco D9800 User Manual

DescriptionCommand Detail
All CI CAM Settings:
GET "https://192.168.0.1/ws/v2/service_cfg/ca/ci"
Single CI CAM Setting:
GET "https://192.168.0.1/ws/v2/service_cfg/ca/ci?sengdquery"
GET Syntax
POST "https://192.168.0.1/ws/v2/service_cfg/ca/ci? sendquery=Enable"POST Syntax
Setting parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
These arguments are intended to be used with POST. When this command is used as a GET command
these arguments generally serve as output field descriptions
Note
Table 202: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
DescriptionURI Argument
Send Query to CAM before enabling descrambling
Type: String
Value: "Enable", "Disable"
sendquery
Auto Reset CAM on failure
Type: String
Value: "Enable", "Disable"
autoreset
CA PMT List management mechanism
Type: String
Value: AddDel, UpdateAll
listmgmt
Transport ID/ Original Network ID check
Type: String
Value: "Enable", "Disable"
tsonetchk
Transport ID
Type: Integer
Value: 0..65535
tsid
Original Network Identifier
Type: Integer
Value: 0..65535
onetid
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
238
API Definitions
CA (Conditonal Access) Configuration Commands

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English