Cisco D9800 User Manual

DescriptionCommand Detail
This command is used to read all the ASI or MOIP DPM active
collision statuses.
Partial response is not supported. This command returns
the status of all active peid and row key combinations for
all output fields for the specified MOIP or ASI.
Note
Command Information
GETHTTP Method
ReadAccess Type
User, AdminAccess Level
GET "https://192.168.0.1/ws/v2/status/output/moip/collision",
GET "https://192.168.0.1/ws/v2/status/output/moip1/collision", or
GET "https://192.168.0.1/ws/v2/status/output/moip2/collision"
Syntax for getting MOIP status output
parameters
GET "https://192.168.0.1/ws/v2/status/output/asi/collision",
GET "https://192.168.0.1/ws/v2/status/output/asi1/collision", or
GET "https://192.168.0.1/ws/v2/status/output/asi2/collision"
Syntax for getting ASI status output
parameters
Table 60: URI <level_1> URI Parameters (extension to the Command URL separated by /)
DescriptionURI Level 1 Parameter
Output type is ASI.
On NTC Basic or NTC MOIP, the supported values are asi or
asi2 for the unique asi output.
On NTC MS, the supported values are asi1 for bidirectional port
1 and asi2 for bidirectional port 2.
asi/asi1/as2
Output type is MOIP.
On NTC Basic, this call is not supported.
On NTC MOIP, the supported values are moip or moip1 for the
unique IP output/
On NTC MS, the supported values are moip1 for IP output 1 and
moip2 for IP output 2/
moip/moip1/moip2
Table 61: URI <level_2> URI Parameters (extension to the Command URL separated by /)
DescriptionURI Level 2 Parameter
DPM Active collision information.collision
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
78
API Definitions
Output Status Command

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English