Cisco IE-3000-8TC Message Guide

2-77
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
VQPCLIENT Messages
Error Message VQPCLIENT-2-PROCFAIL: Could not create process for VQP. Quitting.
Explanation An error occurred while creating a process for the VQP client.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 1-4.
Error Message VQPCLIENT-2-SHUTDOWN: Interface [chars] shutdown by VMPS.
Explanation The VMPS has directed that an interface be shut down. [chars] is the interface name.
Recommended Action No action is normally required. If you think that the port should not have been
shut down, verify the configuration on the VMPS.
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Explanation The system has shut down the specified interface because too many hosts have requested
access to that interface. [chars] is the interface name.
Recommended Action To enable the interface, remove the excess hosts, and enter the no shutdown
interface configuration command.
Error Message VQPCLIENT-3-IFNAME: Invalid interface ([chars]) in response.
Explanation The VMPS has sent an unsolicited response with an unknown interface name. [chars] is
the name of the unknown interface.
Recommended Action Verify the VMPS configuration.
Error Message VQPCLIENT-3-THROTTLE: Throttling VLAN change on [chars].
Explanation An attempt was made to change the VLAN assignment for an interface more often than
once every 10 seconds. The VLAN change is denied. [chars] is the interface name.
Recommended Action No action is normally required. If the message recurs, verify the VMPS
configuration. Verify that unexpected hosts are not connected to the port.
Error Message VQPCLIENT-3-VLANNAME: Invalid VLAN [chars] in response.
Explanation The VLAN membership policy server (VMPS) has specified a VLAN name that is
unknown to the switch. [chars] is the VLAN name.
Recommended Action Ensure that the VLAN exists on the switch. Verify the VMPS configuration by
entering the show vmps privileged EXEC command.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes