6-34
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Chapter 6 Configuring Radio Settings
Viewing VoWLAN Metrics
Note You may also configure the CoS 4 (Controlled Load) user priority and its maximum retries value.
Step 6 Click Apply.
Figure 6-3 Packet Handling Configuration
You can also configure VoIP packet handling using the CLI. For a list of Cisco IOS commands for
configuring VoIP packet handling using the CLI, consult the Cisco IOS Command Reference for Cisco
Aironet Access Points and Bridges.
Viewing VoWLAN Metrics
VoWLAN metrics provide you with diagnostic information pertinent to VoIP performance. This
information helps you determine whether problems are being introduced by the WLAN or the wired
network. VoWLAN metrics are stored on WLSE.
Note The WLSE updates VoWLAN metrics every 90 seconds and stores metrics for up to 1.5 hours.
Viewing Voice Reports
You can use a browser to access voice reports listing VoWLAN metrics stored on a WLSE. You can view
reports for access point groups and for individual access points.
To view voice reports, follow these steps:
Step 1 Log in to a WLSE.
Step 2 Click the Reports tab.
To Next Page
Loading...
Need help?
General
