14-9
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Chapter 14 Configuring VLANs
Configuring VLANs
Using a RADIUS Server for Dynamic Mobility Group Assignment
You can configure a RADIUS server to dynamically assign mobility groups to users or user groups. This
eliminates the need to configure multiple SSIDs on the access point. Instead, you need to configure only
one SSID per access point.
When users associate to the SSID, the access point passes their login information to WLSM, which
passes the information to the RADIUS server. Based on the login information, the RADIUS server
assigns the users to the appropriate mobility group and sends their credentials back.
To enable dynamic mobility group assignment, you need to configure the following attributes on the
RADIUS server:
• Tunnel-Type (64)
• Tunnel-Medium-Type(65)
• Tunnel-Private-Group-ID (81)
Figure 14-2 Dynamic Mobility Group Assignment
Viewing VLANs Configured on the Access Point
In privileged EXEC mode, use the show vlan command to view the VLANs that the access point
supports. This is sample output from a show vlan command:
Virtual LAN ID: 1 (IEEE 802.1Q Encapsulation)
vLAN Trunk Interfaces: Dot11Radio0
FastEthernet0
Virtual-Dot11Radio0
This is configured as native Vlan for the following interface(s) :
Dot11Radio0
FastEthernet0
To Next Page
Loading...
