9-11
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Chapter 9 Configuring an Access Point as a Local Authenticator
Configuring a Local Authenticator
Using Debug Messages
In privileged exec mode, enter this command to control the display of debug messages for the local
authenticator:
AP# debug radius local-server { client | eapfast | error | packets}
Use the command options to display this debug information:
• Use the client option to display error messages related to failed client authentications.
• Use the eapfast option to display error messages related to EAP-FAST authentication. Use the
sub-options to select specific debugging information:
–
encryption —displays information on the encryption and decryption of received and
transmitted packets
–
events—displays information on all EAP-FAST events
–
pac—displays information on events related to PACs, such as PAC generation and verification
–
pkts—displays packets sent to and received from EAP-FAST clients
• Use the error option to display error messages related to the local authenticator.
• Use the packets option to turn on display of the content of RADIUS packets sent and received.
To Next Page
Loading...
Need help?
General
