22-11
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Chapter 22 Wireless Device Troubleshooting
Checking the Top Panel Indicators
Indicators on 1250 Access Points
If your access point is not working properly, check the Ethernet, Status, and Radio LEDs on the 2.4 GHz
end of the unit. You can use the LED indications to quickly assess the unit’s status.Table 22-4 shows the
access point LEDs (for additional information refer to the Event Log using the access point browser
interface).
Figure 22-7 shows the 1250 series access point LEDs.
Figure 22-7 1250 Series Access Point LEDs
ETHERNET STATUS RADIO
230563
ETHERNET STATUS RADIO
To Next Page
Loading...
