C-20
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Appendix C Error and Event Messages
Inter-Access Point Protocol Messages
Error Message SOAP_FIPS-2-SELF_TEST_IOS_SUCCESS: “IOS crypto FIPS self test passed.”
Explanation
SOAP FIPS self test passed.
Recommended Action None.
Error Message SOAP_FIPS-2-SELF_TEST_RAD_SUCCESS: “RADIO crypto FIPS self test passed
on interface %s %d.”
Explanation
SOAP FIPS self test passed on a radio interface.
Recommended Action None.
Error Message DOT11-6-MCAST_DISCARD: “%s mode multicast packets are discarded in %s
multicast mode.”
Explanation
The access point configured as a workgroup bridge and drops infrastructure mode
multicast packets in client mode and drops client mode multicast packets in infrastructure mode.
Recommended Action None.
Inter-Access Point Protocol Messages
Error Message DOT11-6-STANDBY_ACTIVE: “Standby to Active, Reason = %s (%d).”
Explanation
The access point is transitioning from standby mode to active mode for the indicated
reason.
Recommended Action None.
Error Message DOT11-6-STANDBY_REQUEST: “Hot Standby request to shutdown radios from
%e.”
Explanation
The indicated standby access point has requested that this access point shut down its
radio interfaces because a failure has been detected on one of this access point’s radio interfaces.
Recommended Action None.
Error Message DOT11-6-ROGUE_AP: “Rogue AP %e reported. Reason: %s.”
Explanation
A station has reported a potential rogue access point for the indicated reason.
Recommended Action None.
To Next Page
Loading...
Need help?
General
