12-29
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Configuring Radio Management
Figure 12-17 WDS/WNM General Setup Page
Step 4 Check the Configure Wireless Network Manager check box.
Step 5 In the Wireless Network Manager IP Address field, enter the IP address of the WLSE device on your
network.
Step 6 Click Apply. The WDS access point is configured to interact with your WLSE device.
CLI Configuration Example
This example shows the CLI commands that are equivalent to the steps listed in the “Configuring Radio
Management” section on page 12-28:
AP# configure terminal
AP(config)# wlccp wnm ip address 192.250.0.5
AP(config)# end
In this example, the WDS access point is enabled to interact with a WLSE device with the IP address
192.250.0.5.
For complete descriptions of the commands used in this example, consult the Cisco IOS Command
Reference for Cisco Aironet Access Points and Bridges.
To Next Page
Loading...
Need help?
General
