18-12
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Chapter 18 Configuring SNMP
Displaying SNMP Status
AP(config)# snmp-server group admin v3 priv read iso write iso
AP(config)# snmp-server user joe admin v3 auth md5 xyz123 priv des56 key007
AP(config)# snmp-server user fred admin v3 encrypted auth md5 abc789 priv des56 key99
Note After you enter the last command in this example, the show running-config and
show startup-config commands display only a partial SNMP configuration.
Displaying SNMP Status
To display SNMP input and output statistics, including the number of illegal community string entries,
errors, and requested variables, use the show snmp privileged EXEC command. For information about
the fields in this display, refer to the Cisco IOS Configuration Fundamentals Command Reference for
Release 12.3.
To Next Page
Loading...
Need help?
General
