Cisco M10-RM User Manual

12-21
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Configuring Fast Secure Roaming
Using Debug Messages
In privileged exec mode, use these debug commands to control the display of debug messages for devices
interacting with the WDS device:
Configuring Fast Secure Roaming
After you configure WDS, access points configured for CCKM can provide fast, secure roaming for
associated client devices. This section describes how to configure fast, secure roaming on your wireless
LAN. This section contains these sections:
• Requirements for Fast Secure Roaming
• Configuring Access Points to Support Fast Secure Roaming
Requirements for Fast Secure Roaming
To configure fast secure roaming, you must have these items on your wireless LAN:
• At least one access point, ISR, or switch (equipped with a WLSM) configured as the WDS device
• Access points configured to participate in WDS
• Access points configured for fast, secure roaming
• An authentication server (or an access point, ISR, or switch configured as a local authenticator)
• Cisco Aironet client devices, or Cisco-compatible client devices that comply with Cisco Compatible
Extensions (CCX) version 2 or later
For instructions on configuring WDS, refer to the “Configuring WDS” section on page 12-7.
Command Description
debug wlccp ap
{mn | wds-discovery | state}
Use this command to turn on display of debug messages related
to client devices (mn), the WDS discovery process, and access
point authentication to the WDS device (state).
debug wlccp dump Use this command to perform a dump of WLCCP packets
received and sent in binary format.
debug wlccp packet Use this command to turn on display of packets to and from the
WDS device.
debug wlccp wds [aggregator |
authenticator | nm | state |
statistics]
Use this command and its options to turn on display of WDS
debug messages. Use the statistics option to turn on display of
failure statistics.
debug wlccp wds authenticator
{all | dispatcher | mac-authen |
process | rxdata | state-machine |
txdata}
Use this command and its options to turn on display of WDS
debug messages related to authentication.

Cisco M10-RM Specifications

General

Brand	Cisco
Model	M10-RM
Category	Wireless Access Point
Language	English