C-22
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Appendix C Error and Event Messages
Local Authenticator Messages
Error Message DOT1X-SHIM-3-UNSUPPORTED_KM: “Unsupported key management: %X.”
Explanation
Am error occurred during the initialization of the shim layer. An unsupported key
management type was found.
Recommended Action None.
Error Message DPT1X-SHIM-4-PLUMB_KEY_ERR: “Unable to plumb keys - %s.”
Explanation
An unexpected error occurred when the shim layer tried to plumb the keys.
Recommended Action None.
Error Message DOT1X-SHIM-3-PKT_TX_ERR: “Unable to tx packet -%s.”
Explanation
An unexpected error occurred when the shim layer tried to transmit the dot1x packet.
Recommended Action None
Error Message DOT1X-SHIM-3-ENCAP_ERR: “Packet encap failed for %e.”
Explanation
An unexpected error occurred when the shim layer tried to transmit the dot1x packet.
The packet encapsulation failed.
Recommended Action None.
Error Message DOT1X-SHIM-3-SUPP_START_FAIL: “Unable to start supplicant on %s.”
Explanation
An unexpected error occurred when the shim layer tried to start the dot1x suppliant on
the indicated interface.
Recommended Action None.
Error Message DOT1X-SHIM=3-NO_UPLINK: “No uplink found for %s.”
Explanation
While processing a dot1x event or message on a dot11 interface, a situation was
encountered where an uplink was expected, but not found.
Recommended Action None.
Error Message Information Group rad_acct: Radius server <ip address> is responding
again (previously dead). Error Group acct: No active radius servers found. Id 106
Explanation
This message is seen if the radius-server deadtime 10 command is configured on the
access point.This command is configured to set an interval during which the access point does not
attempt to use servers that do not respond. Thus avoids the time needed to wait for a request to time
To Next Page
Loading...
Need help?
General
