Cisco M10-RM - Page 513

Index
IN-7
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
interface configuration mode 3-2
interface dot11radio command 1-1, 1-2, 6-2
interfaces 2-4
intrusion detection 12-1
invalid characters in 14-6
ip domain-name command 5-34
IP filters 16-9
ip redirect command 7-12
IP redirection 7-11, 7-12
IP subnet mask 4-13
ISO designators for protocols A-1
J
Japan upgrade utility
migrating to W52 domain
5-37
verfying the migration 5-39
jitter 15-2
K
key features 1-2
keystrokes (edit CLI commands) 3-6
L
latency 15-2
Layer 3 mobility 12-5
LBS 6-21
LEAP authentication
local authentication
9-1
setting on client and access point 11-20
LED indicators
Ethernet
22-4
radio traffic 22-4
status 22-4
limited channel scanning 19-15
limiting client associations by MAC address 16-6
limiting client power level 6-13
line configuration mode 3-2
load balancing 6-26
local authenticator, access point as 9-1
Location-Based Services 6-21
login authentication
with RADIUS
5-10, 13-7
with TACACS+ 5-15, 13-26
login banners 5-35
log messages
See system message logging
low power condition
22-17
M
MAC address
ACLs, blocking association with
16-6
filter 1-xxi, 16-1, 16-3
troubleshooting 22-19
MAC authentication caching 11-15
MAC-based authentication 9-1, 9-2
management
CLI
3-1
Management Frame Protection 12-24
access points in root mode 12-25
broadcast management frames 12-25
overview 12-25
unicast management frames 12-25
Management Frame Protection 2
configuring
12-26
map,network 2-4
maximum data retries 6-32
Maximum RTS Retries 6-31
MCS rates 6-10, 6-11
Media Access Control (MAC) address 4-4
Message Integrity Check (MIC) 6-26, 10-1, 22-18
message-of-the-day (MOTD) 5-35
messages
to users through banners
5-35