PurposeCommand or Action
Displays information for the specified SAN port
channel.
switch# show san-port-channel database
interface san-port-channel channel-number
Step 2
Displays VSAN configuration information for
the specified Fibre Channel interface.
switch# switch# show interface fc slot/port
Step 3
If this is a QSFP+ GEM, the slot/port
syntax is slot/QSFP-module/port.
Note
Example of Verification Commands
The following example shows how to display a summary of SAN port channel information:
switch# show san-port-channel summary
------------------------------------------------------------------------------
Interface Total Ports Oper Ports First Oper Port
------------------------------------------------------------------------------
san-port-channel 7 2 0 --
san-port-channel 8 2 0 --
san-port-channel 9 2 2
The following example shows how to display SAN port channel consistency:
switch# show san-port-channel consistency
Database is consistent
The following example shows how to display details of the used and unused port channel numbers:
switch# show san-port-channel usage
Totally 3 port-channel numbers used
===================================
Used : 77 - 79
Unused: 1 - 76 , 80 - 256
Autocreated SAN port channels are indicated explicitly to help differentiate them from the manually created
SAN port channels. The following example shows how to display an autocreated port channel:
switch# show interface fc2/1
fc2/1 is trunking
Hardware is Fibre Channel, FCOT is short wave laser
Port WWN is 20:0a:00:0b:5f:3b:fe:80
...
Receive data field Size is 2112
Port-channel auto creation is enabled
Belongs to port-channel 123
...
Default Settings for SAN Port Channels
The table below lists the default settings for SAN port channels.
Table 16: Default SAN Port Channel Parameters
DefaultParameters
FSPF is enabled by default.Port channels
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
OL-30895-01 111
Configuring SAN Port Channels
Default Settings for SAN Port Channels
To Next Page
Loading...
