Cisco Nexus 5500 Series NX-OS - Default Settings for FSFP

The following example shows how to display global FSPF information for a specific VSAN:
switch# show fspf vsan 1
The following example shows how to display a summary of the FSPF database for a specified VSAN. If no
additional parameters are specified, all LSRs in the database are displayed:
switch# show fspf database vsan 1
The following example shows how to display FSPF interface information:
switch# show fspf vsan 1 interface fc2/1
Default Settings for FSFP
The following table lists the default settings for FSPF features.
Table 27: Default FSPF Settings
DefaultParameters
Enabled on all E ports and TE portsFSPF
DynamicSPF computation
0SPF hold time
0Backbone region
5 secondsAcknowledgment interval (RxmtInterval)
30 minutesRefresh time (LSRefreshTime)
60 minutesMaximum age (MaxAge)
20 secondsHello interval
80 secondsDead interval
Derived from the principal switch (root node)Distribution tree information
FSPF stores up to 16 equal cost paths to a given
destination
Routing table
Based on destination ID and source ID on different,
equal cost paths
Load balancing
DisabledIn-order delivery
DisabledDrop latency
If the cost (metric) of the route is not specified, the
default is 10
Static route cost
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
OL-30895-01 185
Configuring Fibre Channel Routing Services and Protocols
Default Settings for FSFP