Cisco Nexus 5500 Series NX-OS - Default Fibre Channel Interface Settings

53584181 frames output, 94072838324 bytes
0 discards, 0 errors
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
1 output OLS, 1 LRR, 0 NOS, 0 loop inits
last clearing of "show interface" counters never
15 receive B2B credit remaining
5 transmit B2B credit remaining
0 low priority transmit B2B credit remaining
Interface last changed at Mon May 19 20:15:53 2014
Default Fibre Channel Interface Settings
The following table lists the default settings for native Fibre Channel interface parameters.
Table 5: Default Native Fibre Channel Interface Parameters
DefaultParameters
AutoInterface mode
AutoInterface speed
Shutdown (unless changed during initial setup)Administrative state
On (unless changed during initial setup)Trunk mode
1 to 4093Trunk-allowed VSANs
Default VSAN (1)Interface VSAN
Off (disabled)Beacon mode
DisabledEISL encapsulation
2112 bytesData field size
The following table lists the default settings for virtual Fibre Channel interface parameters.
Table 6: Default Virtual Fibre Channel Interface Parameters
DefaultParameters
F modeInterface mode
n/aInterface speed
Shutdown (unless changed during initial setup)Administrative state
OnTrunk mode
All VSANsTrunk-allowed VSANs
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
OL-30895-01 27
Configuring Fibre Channel Interfaces
Default Fibre Channel Interface Settings