Cisco Nexus 5500 Series NX-OS - About Fcdomain Initiation; Disabling or Reenabling Fcdomains; Configuring Fabric Names

PurposeCommand or Action
Configures the specified priority for the local switch
in the specified VSAN. The fcdomain priority
fcdomain priority number vsan vsan-id
Example:
switch(config)# fcdomain priority 12
vsan 1
Step 2
ranges from 1 to 254. The VSAN ID ranges from 1
to 4093.
Reverts the priority to the factory default (128) in
the specified VSAN. The fcdomain priority ranges
from 1 to 254. The VSAN ID ranges from 1 to 4093.
no fcdomain priority number vsan
vsan-id
Example:
switch(config)# no fcdomain priority
12 vsan 1
Step 3
About fcdomain Initiation
By default, the fcdomain feature is enabled on each switch. If you disable the fcdomain feature in a switch,
that switch can no longer participate with other switches in the fabric. The fcdomain configuration is applied
to runtime through a disruptive restart.
Disabling or Reenabling fcdomains
To disable or reenable fcdomains in a single VSAN or a range of VSANs, perform this task:
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Disables the fcdomain configuration in the
specified VSAN range.
switch(config)# no fcdomain vsan vsan-id
- vsan-id
Step 2
Enables the fcdomain configuration in the
specified VSAN.
switch(config)# fcdomain vsan vsan-id
Step 3
Configuring Fabric Names
You can set the fabric name value for a disabled fcdomain.
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
OL-30895-01 33
Configuring Fibre Channel Domain Parameters
Fibre Channel Domains