Cisco Nexus 5500 Series NX-OS - Creating Zone Sets and Adding Member Zones

member interface type slot/port
If this is a QSFP+ GEM, the slot/port syntax
is slot/QSFP-module/port.
Note
Local sWWN interface
member interface type slot/port domain-id
domain-id
If this is a QSFP+ GEM, the slot/port syntax
is slot/QSFP-module/port.
Note
Domain ID interface
member interface type slot/port swwn swwn-id
If this is a QSFP+ GEM, the slot/port syntax
is slot/QSFP-module/port.
Note
Remote sWWN interface
member pwwn pwwn-id
pWWN
The following example shows how to configure different types of member alias:
switch(config)# fcalias name AliasSample vsan 3
pWWN example:
switch(config-fcalias)# member pwwn 10:00:00:23:45:67:89:ab
fWWN example:
switch(config-fcalias)# member fwwn 10:01:10:01:10:ab:cd:ef
FC ID example:
switch(config-fcalias)# member fcid 0x222222
Domain ID example:
switch(config-fcalias)# member domain-id 2 portnumber 23
Local sWWN interface example:
switch(config-fcalias)# member interface fc 2/1
Remote sWWN interface example:
switch(config-fcalias)# member interface fc 2/1 swwn 20:00:00:05:30:00:4a:de
Domain ID interface example:
switch(config-fcalias)# member interface fc2/1 domain-id 25
Device alias example:
switch(config-fcalias)# member device-alias devName
Creating Zone Sets and Adding Member Zones
You can create a zone set to include several zones.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
138 OL-30895-01
Configuring and Managing Zones
Zone Sets