Cisco Nexus 5500 Series NX-OS - Default Settings for Fabric Security

Example:
switch# show fcsp dhchap database
DHCHAP Local Password:
Non-device specific password:*******
Other Devices' Passwords:
Password for device with WWN:20:00:00:05:30:00:38:5e is *******
Step 7
Display the DHCHAP configuration in the interface.
Example:
switch# show fcsp interface fc2/4
fc2/4
fcsp authentication mode:SEC_MODE_ON
Status:Successfully authenticated
Step 8
Repeat these steps on the connecting switch.
Example:
MDS-9509# show wwn switch
Switch WWN is 20:00:00:05:30:00:38:5e
MDS-9509(config)# fcsp enable
MDS-9509(config)# fcsp dhchap password rtp9509
MDS-9509(config)# fcsp dhchap devicename 20:00:00:05:30:00:54:de password rtp9216
MDS-9509(config)# interface fc 4/5
MDS-9509(config-if)# fcsp on
MDS-9509# show fcsp dhchap database
DHCHAP Local Password:
Non-device specific password:*******
Other Devices' Passwords:
Password for device with WWN:20:00:00:05:30:00:54:de is *******
MDS-9509# show fcsp interface fc2/4
Fc2/4
fcsp authentication mode:SEC_MODE_ON
Status:Successfully authenticated
You have now enabled and configured DHCHAP authentication for the sample setup.
Default Settings for Fabric Security
The following table lists the default settings for all fabric security features in any switch.
Table 33: Default Fabric Security Settings
DefaultParameters
DisabledDHCHAP feature
A priority list of MD5 followed by SHA-1 for
DHCHAP authentication
DHCHAP hash algorithm
Auto-passiveDHCHAP authentication mode
0, 4, 1, 2, and 3, respectivelyDHCHAP group default priority exchange order
30 secondsDHCHAP timeout value
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
242 OL-30895-01
Configuring FC-SP and DHCHAP
Default Settings for Fabric Security