Cisco Nexus 5500 Series NX-OS - Cloning Zones, Zone Sets, FC Aliases, and Zone Attribute Groups

PurposeCommand or Action
Renames a zone set in the specified
VSAN.
zoneset rename oldname newname vsan vsan-id
Example:
switch(config)# zoneset rename test myzoneset
vsan 60
Step 2
Renames a zone in the specified
VSAN.
zone rename oldname newname vsan vsan-id
Example:
switch(config)# zone rename test myzone vsan
50
Step 3
Renames a fcalias in the specified
VSAN.
fcalias rename oldname newname vsan vsan-id
Example:
switch(config)# fcalias rename test myfc vsan
200
Step 4
Renames a zone attribute group in the
specified VSAN.
zone-attribute-group rename oldname newname vsan
vsan-id
Example:
switch(config)# zone-attribute-group rename
test mygroup vsan 12
Step 5
Activates the zone set and updates the
new zone name in the active zone set.
zoneset activate name newname vsan vsan-id
Example:
switch(config)# zoneset activate name myzone
vsan 50
Step 6
Cloning Zones, Zone Sets, FC Aliases, and Zone Attribute Groups
You can clone a zone, zone set, fcalias, or zone-attribute-group.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Clones a zone set in the specified
VSAN.
zoneset clone oldname newname vsan vsan-id
Example:
switch(config)# zoneset clone test myzoneset2
vsan 2
Step 2
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
144 OL-30895-01
Configuring and Managing Zones
Zone Set Duplication