Screw in 4 captive screws and
tighten each screw to 8 in-lb (0.9
N·m) of torque.
3Hold the 2 fan tray handles with both hands.1
Position the back of the fan tray to the open fan tray slot. The pins
on the top and bottom of the fan tray should align to holes in the
chassis and the 2 sets of rails on the top of the fan tray should align
to 2 sets of tracks on the top of the open slot. Slide the fan tray all
the way into the slot.
2
b) Position the fan tray with its rear (the side with the electrical connectors) at the opening for the fan tray slot in the
chassis.
c) Align the two tracks on the top of the fan tray with the two sets of rails at the top of the open fan tray slot in the
chassis.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
99
Replacing or Installing Modules, Fan Trays, and Power Supplies
Installing a Fabric Module
To Next Page
Loading...
