Cisco RV320 User Manual

Setup
Setup Network
Cisco RV320/RV325 Administration Guide 23
3
• Connection Timers—Connection is disconnected after a period of
inactivity.
- Connect on Demand—When this feature is enabled, the device
automatically establishes your connection. If you enabled this feature,
enter the Max Idle Time, the number of minutes that the connection can
be inactive before the connection is terminated. The default maximum
idle time is 5 minutes.
- Keep Alive—Ensures that your router is always connected to the
Internet. When this feature is selected, the router keeps the connection
alive by sending out a few data packets periodically. This option keeps
your connection active indefinitely, even when the link sits idle for an
extended period of time. If you enable this feature, also enter the Redial
Period to specify how often the router verifies your Internet connection.
The default period is 30 seconds.
• MTU—Maximum transmission unit (MTU) size. Select Auto to set the size
automatically. Otherwise, to set the MTU size manually, select Manual and
enter the MTU size. (The size in bytes of the largest protocol data unit that
the layer can pass.)
Transparent Bridge (IPv4)
Choose this option if you are using this router to connect two network segments.
Only one WAN interface can be set as transparent bridge.
• Specify WAN IP Address—External IP address that your ISP assigned to
your account.
• Subnet Mask—Subnet mask specified by your ISP.
• Default Gateway Address—IP address of the default gateway.
• DNS Server 1 and DNS Server 2—IP addresses of the DNS servers.
Optionally, you can enter a second DNS server. The first available DNS
server is used.
• Internal LAN IP Range—Internal LAN IP range that is bridged. The WAN
and LAN of transparent bridge must be on the same subnet.
• MTU—Maximum transmission unit (MTU) size. Select Auto to set the size
automatically. Otherwise, to set the MTU size manually, select Manual and
enter the MTU size. (The size in bytes of the largest protocol data unit that
the layer can pass.)

Cisco RV320 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
USB version	2.0
USB ports quantity	2
Ethernet LAN (RJ-45) ports	6
Gigabit Ethernet (copper) ports quantity	4
Routing protocols	RIP-1, RIP-2
Supported network protocols	IPv4, IPv6, Static IP, PPPoE, PPTP, DNS, DynDNS
VPN support	IPsec, L2TP, DPD, DNS
Firewall security	Port Address Translation (PAT) firewall, Stateful packet inspection (SPI) firewall, Network address translation (NAT) firewall
Security algorithms	128-bit AES, 192-bit AES, 256-bit AES, 3DES, DES, HTTPS, MD5, SHA-1, SSL/TLS
VPN tunnels quantity	25
Authentication method	SHA-1, MD5
MAC address filtering	-
Certification	FCC, CE, UL, cUL, CB, CCC, BSMI, KC, Anatel
Storage temperature (T-T)	0 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %
Product color	Black
Rack mounting	No
LED indicators	Activity, LAN, Link, Power, USB, WAN
Input current	1.5 A
Output voltage	12 V

Weight and Dimensions

Depth	44 mm
Width	206 mm
Height	132 mm
Weight	- g