Cisco RV320 - Page 58

System Management
Bandwidth Management
58 Cisco RV320/RV325 Administration Guide
5
Bandwidth Management Type
Choose one of the following management options:
• Rate Control—Minimum (guaranteed) bandwidth and maximum (limited)
bandwidth for each service or IP address. You can add up to 100 services.
• Priority—Manage the bandwidth by identifying high-priority and low-
priority services.
Rate Control
To add an interface that is subject to bandwidth management, click Add and enter
the settings:
• Interface—Interface that supports the service.
• Service—Service to manage. If a service is not listed, click Service
Management to add a service.
• IP—IP address or range to control.
• Direction—Select Upstream for outbound traffic. Select Downstream for
inbound traffic.
• Min. Rate—Minimum rate in kbs for the guaranteed bandwidth.
• Max. Rate—Maximum rate in kbs for the guaranteed bandwidth.
Check the box to enable the service.
Configure Priority
To add an interface that is subject to bandwidth management, click Add and enter
the settings:
• Interface—Interface that supports the service.
• Service—Service to manage. If a service is not listed, click Service
Management to add a service.
• Direction—Select Upstream for outbound traffic. Select Downstream for
inbound traffic.
• Priority—Choose the priority for this service: High or Low. Default priority
level is Medium, which is implied and not shown in the web interface.
Check the box to enable this service.