Cisco RV320 - Page 60

System Management
SNMP
60 Cisco RV320/RV325 Administration Guide
5
• Enable SNMPv1/v2c—Enables SNMP v1/v2c.
- Get Community Name—Community string for authenticating SNMP
GET commands. You can enter a name up to 64 alphanumeric
characters in length. The default is public.
- Set Community Name—Community string for authenticating SNMP
SET commands. You can enter a name up to 64 alphanumeric characters
in length. The default is private.
- SNMPv1/v2c Trap Receiver IP Address—IP address or domain name
for the server where you are running your SNMP management software.
• Enable SNMPv3—Enables SNMPv3. (Check the box and click Save before
creating SNMP groups and users.) Follow the instructions in Configuring
SNMPv3.
- SNMPv3 Trap Receiver IP Address—IP address or domain name for
the server where you are running your SNMP management software.
- SNMPv3 Trap Receiver User—Username for the server where you are
running your SNMP management software.
Configuring SNMPv3
You can create SNMPv3 groups to manage SNMP MIB access and identify the
users that have access to each group.
To add or edit a group:
STEP 1 Click Add or select a group and click Edit in the Group Table.
STEP 2 Enter the Group Name.
STEP 3 Select the Security Level from the drop-down menu. Selecting Authentication or
Privacy forces users to authenticate by using passwords. When No
Authentication, No Privacy is selected, none of the users in this group are
required to set an authentication password or a privacy password. The default is
No Authentication, No Privacy. Authentication and Privacy passwords require at
least 8 characters.
STEP 4 Select the MIBs that the members of the group can access.
STEP 5 Click Save.