Cisco SG220-26P Administration Guide

Administration: Discovery
Configuring LLDP
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 96
8
To view LLDP overloading information:
STEP 1 Click Administration > Discovery LLDP > LLDP Overloading.
The following fields are displayed:
• Interface—Port identifier.
• Total By tes In-Use—Total number of bytes of LLDP information in each
packet.
• Available Bytes Left —Total number of available bytes left for additional
LLDP information in each packet.
• Status—If TLVs are transmitted, or if they are overloaded.
STEP 2 Select a port and click Details.
The following fields are displayed:
• LLDP Mandatory TLVs
-
Size (Bytes) —Total mandatory TLV byte size.
-
Status —If the mandatory TLV group is transmitting, or if the TLV group
was overloaded.
• LLDP MED Capabilities
-
Size (Bytes) —Total LLDP MED capabilities packets byte size.
-
Status —Whether the LLDP MED capabilities packets were sent or they
were overloaded.
• LLDP MED Location
-
Size (Bytes) —Total LLDP MED location packets byte size.
-
Status —Whether the LLDP MED location packets were sent or they were
overloaded.
• LLDP MED Network Policy
-
Size (Bytes) —Total LLDP MED network policies packets byte size.
-
Status —If the LLDP MED network policies packets were sent, or if they
were overloaded.
• LLDP MED Expanded Power via MDI

Cisco SG220-26P Specifications

General

Model	SG220-26P
Ports	26
PoE Ports	24
Switching Capacity	52 Gbps
Forwarding Rate	38.69 Mpps
Layer	Layer 2
Power Supply	Internal
VLANs Supported	256
Management	Web-based GUI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Dimensions	440 x 44 x 257 mm
Weight	3.3 kg