2
Cisco SPA525G and Cisco SPA525G2 SIP IP Phone User Guide 23
Installing Your Phone
This chapter describes how to install and connect your IP phone. It contains the
following sections:
• Before You Begin, page 23
• Connecting the Handset, page 24
• (Optional) Attaching the Desk Stand, page 26
• (Optional) Mounting the Phone to the Wall, page 26
• Connecting the Power, page 27
• Connecting Your Phone to the Network, page 27
• Verifying Phone Startup, page 35
• Updating Your Phone Firmware, page 35
Before You Begin
Before you install and connect your phone, verify with your phone system
administrator (if applicable) that the network is ready for the phone, read the
safety notices, and make sure you have all the phone parts and documentation
available.
CAUTION Do not plug a telephone line cord into the port marked AUX. The RJ-11 port marked
AUX is reserved for connection with the Cisco Attendant Console. It is not for use
as a telephone line port or IP device connection.
To Next Page
Loading...
