Claas ARES 656 - Page 105

ARES 506-606 - 02.2005 - GB
G.19
FLOATING POSITION
The two spool valves controlled by the Electropilot have a floating
position.
• Electro spool valve (A) ("y" axis):
- Push the joystick fully forward (beyond the "tight point") and
press the button (7).
- Release both controls. Spool valve No 5A is in floating
position.
• Electro spool valve (B) ("x" axis):
- Push the joystick fully to the right (beyond the "tight point")
and press the button (7).
- Release both controls. Spool valve No 5B is in floating
position.
Any displacement along the "x" or "y" axis will de-activate the
floating position on the corresponding axis.
ADDITIONAL FUNCTION
The impulse buttons (6) located on the knob of lever (1) are used
to control a bale elevator or other functions. To make the other
functions operational, call your approved CLAAS repair agent.
FLOW ADJUSTMENTS
Adjustment is made in the range from 5 to 100% of the available
flow. The flow on the electro spool valve (A) is adjusted with the
potentiometer (3). The flow on the electro spool valve (B) is
adjusted with the potentiometer (4).
Note: When connecting new implements, make preliminary
tests with a minimum flow setting (buttons (3) and (4) to a
stop, counterclockwise).
- To decrease the flow, turn the potentiometer to the left
(counterclockwise).
- To increase the flow, turn the potentiometer to the right
(clockwise).
391hsn08
391hsn06
395msn06
3
4 5
7
X
Y
6
5
BA
5
A
B