ARES 506-606 - 02.2005 - GB
H.5
USING THE FRONT POWER
TAKEOFF
START-UP
Important: The front power take-off must be started or
stopped with the engine at idling speed.
- Press button (1).
Note: The notch (3) on the switch locks the control button (1)
and avoids accidentally starting up the front power take-off.
- Indicator (2) included in the combination control comes on.
- Accelerate the engine.
- To visualise the front power take-off speed on the console
display panel (4), press the end of control lever (5) until the
warning light appears (6).
STOP
- Engine idling.
- Press button (1).
- Indicator (2) included in the combination control goes out.
411hpn06
601hpn20
601hsn08
60hpn12
Do not wear loose fitting clothing that might get
caught in moving parts. The engine must be
stopped before coupling or uncoupling the
attachment's universal joint shaft. When working, all the
universal joint system must be in place. When repairing,
adjusting or lubricating an attachment in the field,
always set the PTO lever to neutral and stop the engine.
When the PTO is not being used, replace the protective
cover.
3
1
2 46
5
To Next Page
Loading...
