ARES 506-606 - 02.2005 - GB
H.4
HITCH
ARM ADJUSTMENT
To change from "road" (1) position to "work" (2) position:
- Take out axle (L).
- Lower the linkage arm.
- Replace the axle.
Important: When the front linkage is not in use, place the
arms in the road position (1) and immobilise the top thrust
arm.
ADJUSTING THE TOP LINKAGE
Note: Tractor side, there are 2 attachment points (B) to
secure the top linkage.
- Turn the center part to adjust the length of the linkage.
Secure the linkage to the tool beam once adjustment is
completed.
411hpn02
411hpn03
411hpn0
4411hsn05
Stop the engine and apply the hand brake
before carrying out any adjustments to the
linkage arms.
The threaded lengths that are exposed (D) must
be equal ( maximum deviation 5 mm). The
centreline distance (E) of the top linkage must
not exceed 680 mm.
L
1
L
2
B
To Next Page
Loading...
