Claas ARES 656 - USING THE FRONT LINKAGE SYSTEM

ARES 506-606 - 02.2005 - GB
H.3
USING THE FRONT LINKAGE SYSTEM
Lever (1) controls the supply to the front linkage actuators and to
the pressure take-offs at the rear of the tractor.
- Place valve (R) in position (O).
- Manoeuvre the (1) to 4 position lever:
Position A: Power supply (raise linkage).
Position B: Neutral.
Position C: Power supply (lower linkage).
Position D: Floating . Enables the hitched implement to follow the
undulations of uneven ground.
IMPORTANT: Do not use the rear power take-offs when the
front linkage is in use.
Note: When the tractor is equipped with the Electropilot, the
front linkage control is systematically on the "y" axis of
lever (7). Operation of lever (7): see chapter "G".
411msn03
411hsn04
391hsn06
On the road or when the linkage is no longer in
use, place valve (R) in the closed position (F).
2
R
F
O
7
X
Y
6