ARES 506-606 - 02.2005 - GB
D.5
ENGINE STARTING HELP WHEN
COLD
FUEL HEATER
A fuel heater (1) may be installed on the fuel filter head. This
heater is automatically switched on and off depending on the
environmental temperature. For more information, contact your
approved CLAAS repair facility.
COOLING FLUID HEATER
For countries where the temperature is near to or lower than 0 °C,
a cooling fluid heater can be used (2) in addition to the
pre-heating device for starting-up already installed.
The cooling fluid heater is screwed in place of plug (3). Power for
the heater is provided by connecting plug (4) to a 220 V power
source.
Note: The heating time depends on the ambient temperature
(e.g.: at - 15 °C heating for about 2 hours). If the temperature
is below - 15 °C, increase the heating time.
STOPPING THE ENGINE
Immobilize the tractor and place the gear lever and on-load
reverser lever in neutral, then apply the hand brake.
Allow the engine to run at idle speed for 1 or 2 minutes then
switch off the ignition switch (A).
Note: When the engine is stopped, some of the dashboard
and transmission display warning lights remain alight for
several seconds before going out.
101hrn01
101msn02
101hsn02
601hrn02
Before stopping the engine, lower the
implements to the ground and apply the hand
brake. Do not leave the engine running for long
periods in an enclosed area: the exhaust gases can
cause asphyxiation.
3
2 4
To Next Page
Loading...
