ARES 506-606 - 02.2005 - GB
D.3
OPERATIONS BEFORE START
Carry out the operations included in the 10 hour check (see
chapter "L"):
- Place the transmission in neutral (1).
- Check that the power take-off engagement control (2) is in the
stop position.
- Check that the auxiliary spool valve control levers (3) and (4)
are in neutral.
Switch on the ignition.
- Check the fuel level (5).
- Check the brake fluid warning light (6).
Note: If the warning lamp (6) stays on it means that the brake
fluid level is too low. With the engine running, if the warning
light (6) comes on it causes the "stop" (7) warning light and
alarm to function..
601hsn01
601hsn02
Under these circumstances, do not use the
tractor. There is a leak in the brake circuit. Get
in touch urgently with your CLAAS approved
repairer.
Before starting the tractor, make sure that you
have carried out all the preliminary operations
described above, and that there is no-one close
by.
6
7
5
To Next Page
Loading...
