ARES 506-606 - 02.2005 - GB
G.24
PICKER HOOK
COUPLING AN IMPLEMENT
- From the driving position, raise the linkage bars fully using
mode selector (1).
- Activate the spool valve (2), in floating position (A).
- Activate lever (3) to free the lock couplings.
- Lower the linkage arms to bring the coupling to the desired
height.
- Carefully reverse the tractor making sure that the coupling
does not sink into the ground.
- Activate spool valve (2):
• Position (A): Floating, uncoupling.
• Position (B): Coupling outlet.
• Position (N): Neutral.
• Position (C): Coupling return.
Use the rear window rear-view mirror (4) to engage the coupling
in the trailor eyelet. Raise the linkage bars fully using (1) in high
position. The hitch is locked in high position by the couplings (5).
Activate the spool valve (2) in position (C), until lengthwise
locking (6) of the lower frame.
- Lower the linkage bars so that the weight of the equipment is
carried by the hitch frame and not by the lift rods.
- Make sure that the equipment is hitched correctly and safely
locked in position.
- Position (A) is reserved for the use of the distributor without
the pickup hook.
- Position (B) is reserved during hitching and unhitching.
N.B.: As the pickup hook is supplied in flexible hoses,
nothing stops them being connected to the other
distributors, which modifies the instructions described
above.
542hsn02
542msn01
542msn02
2
A
1
3
B
N
C
4
6
5
A B
To Next Page
