ARES 506-606 - 02.2005 - GB
A.7
As a general rule: Make sure the unions are tight and the
pipes in good condition before putting the system under
pressure.
Never loosen a union when the circuit is under pressure.
For any repairs to the hydraulic system, stop the engine and
lower the implement to the ground.
Maintenance - greasing: Always stop the engine.
ELECTRICAL SYSTEM
Knowledge and skill are required to work on the electrical
system. If the need arises (installation of miscellaneous
accessories, radio etc.) contact your approved CLAAS repair
agent.
Moreover:
• Always disconnect the battery negative terminal before
working on the electrical system.
• Never weld on the tractor or on a towed implement.
• Never "patch-up" electric circuits.
•
Never replace a blown fuse with a larger calibre fuse;
you could cause a fire
.
•
Never carry out work on components such as the
alternator or the fan motor when the engine is running
.
•
If you have to carry the battery, ensure that the acid
does not contact the skin; protect your eyes from
splashing
.
FUEL
RE-FUELLING
Before filling the tank, always carefully clean around the fuel
cap to remove any pieces of straw, twigs, etc. which could
help start and then propagate a fire.
Moreover:
•
Never fill the tanks when the engine is running or near
a naked flame
.
•
Do not smoke when filling with fuel
.
COOLANT
Do not work on the cooling system when the engine is
hot (risk of burns).
001hsn10
001hsn11
To Next Page
Loading...
