ARES 506-606 - 02.2005 - GB
A.9
OPERATION
GENERAL RULE
As a general rule, always use equipment in good condition,
suitable for the size of the tractor and the type of work.
WHEEL TRACK
Always use the maximum track compatible with the work in
hand, to reduce the risks of overturning.
ATTACHING IMPLEMENTS
To hitch or unhitch an implement, place the gear lever in
neutral and apply the hand brake. Use a low gear for all
tractor manoeuvres.
Sufficient front-end ballast must be used if the implement
is heavy, to prevent the tractor rearing-up.
Drawbar: This is not intended as a trailer towing hitch and is
not designed to carry vertical loads.
Use the safety equipment provided to hitch implements
(towing jaw, towing stub, retaining pins, etc.).
During hitching operations or when using the external
linkage control, the operator must remain outside the
hitch frame.
The pin situated on the front must only be used to tow the
tractor using a bar on firm ground. In no circumstances must
it be used to pull an implement or a tractor stuck in mud..
DRIVING
Do not enter or leave the tractor when it is in motion.
Avoid risk of overturning:
Do not turn sharply when working on slopes. Maximum slope
allowed while working: See chapter K.
During a break in work, even if only brief, stop the engine and
apply the handbrake. If the ground slopes, engage a gear.
Lower the implement to the ground.
001hsn14
To Next Page
Loading...
