ARES 506-606 - 02.2005 - GB
E.8
GEAR LEVER
GEAR SELECTION (A)
Lever (A) can be used when the tractor is moving. To do this,
release the accelerator pedal, press the clutch pedal, engage the
selected gear, clutch gradually, and accelerate.
SELECTION OF THE "HARE" ROAD AND "TORTOISE"
FIELD RANGES (B)
The road and field ranges are hydraulically controlled: the range
can be changed only with the engine running. To select the
desired range, bring the gearshift lever (A) back to neutral, then
press the range button (B). The change of range can be observed
on the display (the hare (2) or tortoise (1) symbol lights up). A
change of range can be performed with the tractor in motion
provided:
- The change of field/road range is made at a forward speed of
less than 8 km/h.
Note: When the engine is started, the range gear is the same
as that engaged when the engine was stopped.
SELECTION OF SPEED (C)
The speed is changed using the 2 impulse buttons (C), placed on
the gear lever (A) or on the right side post.
The function of TWINSHIFT or QUADRISHIFT is to reduce or
increase the forward speed while working, without affecting the
traction force, by going under torque.
Activate one of the impulse buttons (C):
- Upper (+)impulse button to increase speed ;
- Lower (-) impulse button to decrease speed.
The speed selected is shown on the display. If the driver presses
button (C) several times, the request is memorised. Going
through speeds 2 and 3 of QUADRISHIFT is obligatory.
Note: When the engine is started up, it is still in the last
speed selected when the engine stopped.
601hsn18
601hsn30
601hpn07
B A
C
12
1
To Next Page
Loading...
