To set up the interfaces
6-20 Chapter 6: Configuration of the AVIATOR 200/300/350 system 98-127093-H
To change the local IP address of the SBU do as follows:
1. From the left navigation pane, select SETTINGS > LAN.
Figure 6-17: Web interface: Settings, LAN
2. At DHCP status, select Enabled (recommended), or Disabled.
• Enabled: The SBU assigns dynamic IP addresses to devices connec
ted to the SBU.
• Disabled: You need to set up a static IP address in the connected device.
3. To change the Local IP address and the Netmask, type in the new address and
netmask. B
y default, the address is 192.168.0.1 and the netmask is 255.255.255.0.
4. Click Apply.
Port forwarding
Port forwarding enables you to set up a server connected to the SBU while the terminal is in
Router mode. Without port forwarding it would not be possible to contact the server from
the Internet. If you want to use port forwarding, the global IP address of the SBU should be
a static IP address. Check with your service provider for availability of a static global IP
address. Note that if not agreed otherwise, the global IP address of the SBU will be
dynamically assigned as the SBU signs on to the BGAN network.
For information on how to set the terminal in Router mode, see Set up the network user
groups on page 6-59.
The following example shows how to allow internet access to a mail server (smtp)
connected to the terminal.
CAUTION! This page is by default not protected by an admin password.
You can limit access to this page for certain user groups, for further details
see Set up user permissions on page 6-87.
SB-Lite.book Page 20 Tuesday, September 5, 2017 1:38 PM
To Next Page
Loading...
Need help?
General
