Administration
98-127093-H Chapter 6: Configuration of the AVIATOR 200/300/350 system 6-91
6666
When a data session is started with the Default network user group, the terminal will start
sending ping commands to the Primary IP address the number of times specified at
Retries. If no response is received, it will send the same number of ping commands to the
Secondary IP address, if available. If no response is received here either, the terminal will
reboot.
6.7.14 Restricted dialing
In order to manage the use of the AVIATOR 200/300/350 system efficiently you can set up
the SBU to limit all calls to allowed numbers or numbers in the phone book. This feature can
be enabled for each connected handset separately. For a detailed description how to
restrict dialing see the AVIATOR 200/300/350 user manual.
6.7.15 Multi-voice (option)
You can subscribe to Multi-voice with or without additional numbers. Multi-voice is
disabled per default.
You must have Multi-voice in your airtime subscription, AVIATOR Wireless
Handset software version minimum 1.03 and SBU software version minimum
AVIATOR 200/300/350 (Level E): 1.07, AVIATOR 200D/300D/350D (Level D):
2.01, in order to support the Multi-voice function.
Table 6-10: Multi-voice, number of calls
Multi-voice
AVIATOR 200
LGA (Class 15)
AVIATOR 300 IGA
(Class 7)
AVIATOR 350 HGA
(Class 6)
Number of voice
calls
2 (best effort
quality)
Up to 9 (best effort
quality)
Up to 9 (best effort
quality)
To enable Multi-voice, do as follows:
1. Enter the web interface of your terminal.
2. Select Administration > Multi-voice.
3. Select Multi-voice.
If you want to use an external PBX, select Using external Multi-voice PBX and
select the interface used to connect the PBX to the terminal
You are now ready to use Multi-voice. For more detailed information about configuring
Multi-voice see Configure Multi-voice on page 6-95.
Note
Important
For software 4.00 and higher and SB-Safety Voice: Do not enable Multi-
voice. Multi-voice is disabled automatically when enabling SB-Safety
Voice.
SB-Lite.book Page 91 Tuesday, September 5, 2017 1:38 PM
To Next Page
Loading...
Need help?
General
