To set up the interfaces
6-28 Chapter 6: Configuration of the AVIATOR 200/300/350 system 98-127093-H
2. Select the APN. You have the following options:
• SIM def
ault. The APN is taken from the SIM card. This is the recommended option,
unless you have special requirements, i.e. your service provider does not
automatically provision for PS services.
• Network assigned. The APN is assigned from the network.
• User defined. Type in the APN. APNs are provided from the service provider.
3. At Buff
ering on Streaming profiles, select Enabled or Disabled.
• If you select Enabled, y
our Streaming connection will be buffered. This means that
the transmission is slightly delayed in order to ensure a precise and continuous data
stream.
• If you select Disabled, the Streaming connection will not be buffered. This means
the data is delivered immediately, but may vary slightly in transmission speed.
4. Click Apply.
How to use the common APN
When you configure the APN for your individual network user group, select Common to
use the setting from this page.
Where Common is selected in the individual network user groups, the setting will
automatically be updated when the Common APN is changed.
6.5.8 Set up call services
The setup of call services is also common for all interfaces.
The SBU must be registered on the BGAN network before
you can set up the call services in the web interface.
In the web interface you can set up the following supplementary services:
• Call forwarding
• Call barring
• Call waiting
• Line identification
• Closed user group
• Local exchange
Note that, depending on the network, some of these call service settings may prevent
others from being activated.
The settings apply for all connected devices using a circuit-switched service.
Note
Use User defined if your service provider does not automatically provision your
SIM card. Contact your service provider for an APN or check the
documentation received from the service provider for an APN.
Note
SB-Lite.book Page 28 Tuesday, September 5, 2017 1:38 PM